DW DWSM1207 Delta Ball-Bearing Hinge for 5000, 8000 and 9000 Pedals
The SM1207 is the ball-bearing hinge used on the brand's high-end bass drum pedals. It replaces a sliding pivot with bearings, and the whole feel of the footboard return changes: less friction at the start, less drift as the pedal warms up.
What sets it apart
- Ball-bearing hinge for the 5000, 8000 and 9000 Series
- Removes the starting friction of a sliding pivot
- Even footboard return from the start of the show to the end
- Works as an upgrade as well as a replacement
- Red finish
What bearings change in the feel of the footboard
A basic hinge works by sliding: two surfaces rub against each other. It takes a little force to get the motion started, and that force varies with temperature, dust and the age of the part.
Bearings remove that threshold. The footboard moves at the slightest pressure and, above all, it moves the same way on the twentieth song as on the first. For nuanced playing, where ghost notes on the bass drum matter as much as accented ones, it is the most audible difference such a small part can make.
An upgrade as much as a repair
People usually buy it because the old hinge has developed play. But the manufacturer also presents it as an upgrade part: fitting bearings to a pedal that did not have them changes the feel without touching the drive, the spring or the geometry.
Before ordering, check your pedal's series. This part is listed for the 5000, 8000 and 9000; 3000 and 7000 Series pedals take a different type of hinge.
Specifications
| Type | Ball-bearing footboard hinge |
|---|---|
| Stated compatibility | 5000, 8000 and 9000 Series pedals |
| Use | Upgrade or replacement |
| Finish | Red |
What it is for
- A 5000, 8000 or 9000 pedal whose hinge has developed play
- Upgrading a pedal that is otherwise in good shape
- Nuanced playing where the footboard has to respond instantly
- Long shows where the feel must not drift
- Bringing a used high-end pedal back up to spec
Compare with other manufacturers
Low-friction footboard hinges from other manufacturers:
| Manufacturer | Comparable part | What differs |
|---|---|---|
| Tama | High-end Iron Cobra hinge | Built into the base plate, rarely sold as an upgrade part |
| Pearl | Eliminator Redline hinge | Design specific to the Pearl frame, not transferable |
| Trick | Pro1-V pedal hinge | Pedal built around bearings from the start |
| Axis | Direct drive pedal hinge | Entirely different architecture, no equivalent part |
Frequently asked questions
- How is it different from a regular hinge?
- This one works on bearings rather than by sliding. The footboard takes less force to start moving and stays consistent, whatever the age of the part and the length of the show.
- Which pedals does it fit?
- The manufacturer lists it for the 5000, 8000 and 9000 Series. The 3000 and 7000 Series take a different part.
- Is it a repair or an upgrade?
- Both. It replaces a worn hinge, and it can also go on a healthy pedal to change how the footboard feels at the start of the stroke.
- Do I need to readjust the pedal after installing it?
- The geometry does not change, but the friction does. Readjust the spring tension: a footboard that moves more easily often calls for a slightly different setting.
Avis clients
Does your footboard need a little push before it starts moving?
Aucun avis pour le moment. Soyez le premier à partager votre expérience après votre achat.